Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Silver Spring, MD

CHI Overhead Doors Garage Door Roller Replacement in Silver Spring, MD

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

From the first phone call to the final safety test, CHI Overhead Doors garage door roller replacement in Silver Spring, MD follows a simple process: diagnose, quote, repair, test. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Whether your CHI Overhead Doors garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

When to call for CHI Overhead Doors garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

Common causes

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

Safe checks before you call

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle CHI Overhead Doors garage door roller replacement

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

How much does CHI Overhead Doors garage door roller replacement cost?

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

CHI Overhead Doors Garage Door Roller Replacement in Silver Spring, MD

With large seasonal temperature swings in Maryland, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our CHI Overhead Doors garage door roller replacement service covers Silver Spring (ZIP codes 20901, 20902, 20903, 20904, 20905 and more) and nearby towns including Georgia Avenue / Walter Reed, DC (0.6 mi), The Parks At Walter Reed, DC (1.2 mi), Takoma Park (1.3 mi) and Brightwood, DC (2 mi). Call (833) 435-8883 to book a visit in Silver Spring.

CHI Overhead Doors Garage Door Roller Replacement: frequently asked questions

How much does CHI Overhead Doors garage door roller replacement cost in Silver Spring, MD?

CHI Overhead Doors Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Maryland or Silver Spring requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Silver Spring, MD

Garaga Garage Door Panel Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $300-$900

Craftsman Opener Circuit Board Replacement

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $175-$400

Raynor Weather Seal Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $100-$300

Wayne Dalton Garage Door Track Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$400

Sommer Garage Door Opener Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$350

Overhead Door Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Chain Drive Opener Repair

Chain-drive openers repaired, re-tensioned or replaced.

Typical $125-$350

Linear Remote & Keypad Programming

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $50-$150

Wayne Dalton Torsion Spring Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $200-$450

Broken Garage Door Spring Repair

Fast replacement of broken torsion or extension springs, sized to your door's weight.

Typical $200-$450

Raynor Garage Door Opener Installation

New chain, belt, screw-drive and wall-mount openers installed and programmed.

Typical $350-$800

Trac-Rite Roll-Up Door Repair

Trac-Rite roll-up doors are widely used in self-storage buildings.

Typical $150-$600

Garage door stuck, noisy or broken?

Talk to a garage door technician in Silver Spring, MD now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote