Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Silver Spring, MD

CHI Overhead Doors Commercial Garage Door Repair in Silver Spring, MD

Repairs for commercial sectional, overhead and service doors. Typical cost $250-$1,000.

Our CHI Overhead Doors commercial garage door repair service in Silver Spring, MD comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Repairs for commercial sectional, overhead and service doors. We work on CHI Overhead Doors commercial doors of every age, from older models to current lines, and carry or can source compatible parts.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Signs you need CHI Overhead Doors commercial garage door repair

  • The door won't open or close, holding up deliveries
  • Damage from forklifts or trucks
  • Broken springs or cables on a heavy commercial door
  • The operator faults or stops

Common causes

  • High cycle counts
  • Vehicle impact
  • Worn springs, cables and rollers

Safe checks before you call

  • Put the door out of service and keep staff clear.
  • Note any fault codes on the operator.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our CHI Overhead Doors commercial garage door repair process

  1. Secure the door and assess the damage
  2. Quote parts and labor
  3. Repair springs, cables, sections or track
  4. Adjust or repair the operator
  5. Test safety devices

Typical CHI Overhead Doors commercial garage door repair prices

$250-$1,000Typical range, parts & labor
1-4 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

Serving Silver Spring, MD and nearby towns

With large seasonal temperature swings in Maryland, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Technicians serve all of Silver Spring (ZIP codes 20901, 20902, 20903, 20904, 20905 and more), plus Georgia Avenue / Walter Reed, DC (0.6 mi), The Parks At Walter Reed, DC (1.2 mi), Takoma Park (1.3 mi) and Brightwood, DC (2 mi). Call (833) 435-8883 to book a visit in Silver Spring.

CHI Overhead Doors Commercial Garage Door Repair: frequently asked questions

How much does CHI Overhead Doors commercial garage door repair cost in Silver Spring, MD?

CHI Overhead Doors Commercial Garage Door Repair typically costs $250-$1,000 including parts and labor, and usually takes 1-4 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors commercial garage door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors commercial garage door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Maryland or Silver Spring requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Silver Spring, MD

Garaga Garage Door Panel Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $300-$900

Craftsman Opener Circuit Board Replacement

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $175-$400

Raynor Weather Seal Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $100-$300

Windsor Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Wayne Dalton Garage Door Track Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$400

Sommer Garage Door Opener Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$350

Chain Drive Opener Repair

Chain-drive openers repaired, re-tensioned or replaced.

Typical $125-$350

Linear Remote & Keypad Programming

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $50-$150

Wayne Dalton Torsion Spring Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $200-$450

Broken Garage Door Spring Repair

Fast replacement of broken torsion or extension springs, sized to your door's weight.

Typical $200-$450

Raynor Garage Door Opener Installation

New chain, belt, screw-drive and wall-mount openers installed and programmed.

Typical $350-$800

Garage door stuck, noisy or broken?

Talk to a garage door technician in Silver Spring, MD now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote